Suspended Glass Shelf Units - Complete Cable System & Glass Shelving Included!

Suspended Glass Shelf Units feature glass shelving boards and all the necessary suspension wires & fittings to create a shelving system suspended between the ceiling and the floor. Each complete suspended glass shelving unit consists of (4) cable wires with ceiling-to-floor fixings and (4) shelf supports for each shelf.

This innovative system eliminates the need for holes in the glass; with modern shelf supports, you can add or remove any shelf board from the cables at any time. This design enables the addition of shelving boards without disturbing or removing the adjacent shelves already in place, both above and below. Our glass shelf boards are toughened safety glass and come in various sizes, with a choice of clear or frosted finishes.

Suspended glass shelf units (Up to 1m length):

• 1 shelf: (1) glass shelf board, (4) ceiling-to-floor fittings with 4m cable, (4) shelf supports
• 2 shelves: (2) glass shelf boards, (4) ceiling-to-floor fittings with 4m cable, (8) shelf supports
• 3 shelves: (3) glass shelf boards, (4) ceiling-to-floor fittings with 4m cable, (12) shelf supports
• 4 shelves: (4) glass shelf boards, (4) ceiling-to-floor fittings with 4m cable, (16) shelf supports
• All screws & wall plugs included

Suspended glass shelf units (1.5m & 2m length):

• 1 shelf: (1) glass shelf board, (6) ceiling-to-floor fittings with 4m cable, (6) shelf supports
• 2 shelves: (2) glass shelf boards, (6) ceiling-to-floor fittings with 4m cable, (12) shelf supports
• 3 shelves: (3) glass shelf boards, (6) ceiling-to-floor fittings with 4m cable, (18) shelf supports
• 4 shelves: (4) glass shelf boards, (6) ceiling-to-floor fittings with 4m cable, (24) shelf supports
• All screws & wall plugs included

Note: Cables can be cut shorter to the required length during installation.

How to install ceiling-to-floor cables & fittings:

1. The ceiling & floor fixings unscrew into two pieces.
2. First, screw the brass part of the ceiling fixture into the ceiling, then reattach its chrome cap. The brass part should be hidden under the chrome cap if done correctly.
3. Suspend the cable from the ceiling part by passing it through the small hole in the floor fixing and through the spring underneath.
4. Cut the cable to the desired length and attach the cable-stopper cylinder to the end of the cable by tightening the small screws on the cylinder.
5. Screw the bottom part of the floor fixing into the floor, and then securely attach the top part to it. The spring inside the floor fitting will provide tension to the cable, keeping it straight and tight.
6. Install four cables from the ceiling to the floor to create a column, by attaching four panel supports per shelf board, two on the left cable and two on the right cable.
7. You can easily add as many shelves as you like at any time, using additional shelf supports!