A3 Double-sided Retail Display Shelf

Ceiling to floor cable display glass shelf system, an A3 poster panel in the centre creates a divide between glass shelving, so you can have a promo on both sides! It uses a single 30x30cm glass sheet to create the two 30x15cm shelving. This is a double-sided retail display unit, so the A3 acrylic poster pocket/panel can display promotion materials on both sides. 

This cable shelf system is designed as such, it can be installed as a central part of any shop floor or exhibition stand. And it's versatility makes it an easy & effective way of promoting a wide range of retail products, from electronics like mobile phones & mp3 players, to shoes & clothing asessories, and even as a demo stand for cosmetics!

All cable display fittings are made from a high quality solid brass, with polished chrome finish. System uses 1.5mm thick steel cables. We only deal in toughened safety glass for our products, and premium quality acrylic display panels. A complete A3 Double-sided Display Shelf system consists of:

• 1x Glass Sheet
  (30x30 = 2x '30x15cm' shelves)
• 1x A3 Acrylic Poster Pocket
• 4x Ceiing to Floor Cable & fittings (Suspends Shelf Unit)
• 2x Ceiling Cable & fittings (Suspends Poster Panel)

Step by step installation for cable shelf system:

1. Mark on the Ceiling the position for your first fitting
2. Measure according to distance the position for the other ceiling fittings, and using 'Level Tool' align both & create a second mark, thrid mark etc
3. Drill holes where you created your marks, and then insert wall plugs. make sure wall plugs fully inserted and are flush with the ceiling
4. Unscrew the 'grub screws' at the bottom of the supports, a support will split into it's 2 pieces (Brass screw ring & chrome cap)
5. Take a small brass screw ring, and screw it into the ceiling. (repeat this for all ceiling fittings)
6. Slot the support onto the brass screw rings, they will go inside the support and should be completely hidden! Now re-tighten the side grub screw, so the support can not be removed. (repeat this for all ceiling fittings)
7. Mark on the floor the position your first fitting needs to be. Measure according to distance the position for the other floor fittings, and using 'Level Tool' align both & create a second mark, thrid mark etc
8. After drilling holes and placing plugs, unscrew floor fitting into two. screw the bottom part into the floor; and reattach the 2 parts together
9. Lastly, using the shelf supports, attach the glass shelf to the ceiling to floor suspended cables