Ceiling-to-Wall Cable & Tensioner Display Kit - 4m Steel Wire & Fittings Only

With the Ceiling-to-Wall Cable & Tensioner Display Kit, you can create professional displays for walls & windows to exhibit posters, advertising & signage. A cable system mounted between the ceiling & wall, ideal for various businesses such as small retail shops & large department stores, supermarkets, estate letting agents, travel agencies, restaurants, hair and beauty salons. These ceiling-to-wall cable display fittings utilise 1.5mm steel cable braced using a wire tensioner. The cable fittings screw directly into the ceiling & wall with the cable fitted between them. The wire tensioner keeps the cable taut over time, adapting to temperature changes and heavy usage. Once installed, multiple vertically suspended steel wires support high-quality acrylic poster pockets (sold separately) to present advertising, prices, and signage. They are dual-sided, allowing for posters on both sides - ideal for simultaneous inward/outward-facing window advertising!

Ceiling-to-Wall Cable & Tensioner Display Kit contains a single cable drop featuring (1) ceiling fitting, (1) wall fitting, (1) wire tensioner, and (1) 3m long, 1.5mm steel cable. Creating a complete cable display system will require at least 2 suspended cables to mount the poster panels correctly!

Ceiling-to-wall cable & tensioner display system - installation:

1. Separate the tensioner into two pieces so the ceiling fitting & wall fitting are now separated (with their own length of cable attached).
2. Separate the ceiling fitting from the brass screw mount inside its chrome shell.
3. Screw the brass mount into the ceiling, and reattach the ceiling shell with cable.
4. With the cable suspended from the ceiling fitting as a guide, mark a point for the wall fitting.
5. Separate the wall fitting into two pieces.
6. Screw the wide base into the wall for the bottom of the display, and reattach the long nose.
7. With the fittings installed, fit the tensioner back together and adjust it (by twisting the 2 ends) until the cable is taut.
8. If the cable is too long, loosen the small grub screw on the wall fitting, pull more cable through, and retighten it.
9. Once the cable is in the correct state, remove any extra cable dangling from the bottom with cutters.
10. Repeat the above steps for the next wall-to-wall cable fittings - always keep in mind the width of the posters or signage you will be displaying!
11. If the cables begin to waver and sag over time, tighten the wire tensioner.