A0 LED Display Pocket & Wall to Wall Kit (Rod System / Ready to Use)

Ready to use LED Display Pockets are available in Portrait & Landscape orientation; A0 standard size. Dual-sided acrylic holders allow 2 Posters to be inserted into a single pocket, enabling adverts to be displayed inward & outward facing in your window display! Pocket insert size: 841mm x 1189mm. Wall to Wall Rod Display System with all chrome fittings, and 1.5m long 6mm Steel Rods. Rods have threaded ends, enabling multiple rods to be screwed together to create longer lengths!

Complete A0 Display LED Pocket Kits include:

• 1x LED A0 Pockets, Portrait or Landscape
• LED Driver / Transformer & 5m electrical wiring with 3 pin plug (UK)
• 2x Power Connectors
• 2x Wall to Wall Display Rod System Sets, including 4x 1.5m Rods
• Display Pocket Supports, 4 per Panel (Attach Pockets to Suspended Rods)

Installing the Cable Display System:

1. Seperate the wall fittings, by unscrewing their stem from their screw mount
2. Install the screw mounts onto the wall, the top & botom most position of your display space
3. Re-attach the stems to the screw mounts, and rotate them so the holes on their tips are aligned
4. From the top fitting, pass a rod downward through the stem's hole
5. Add 1 Power Connector onto the rod
6. Continue passing the rod downward until it sits inside the bottom wall fitting
7. Cut away any access rodding length
8. Repeat above steps for the opposite Wall to Wall fittings (Use an LED pocket's width as a guide!)
9. Attach your LED Display Pockets to the suspended rods, using the Supports provided (Allen / Hex Key Supplied)

Although this is a safe low-voltage product, please remember to UNPLUG & SWITCH OFF any power while installing!

Installing LED Driver / Transformer:

1. Attach a naked-end wire to one of the Power Connector on a suspended rod
2. Secure the Power Connector by tightening the small grub-screw on the relevant side
3. Attach the other wire to the Power Connector of the opposite rod
4. Secure the Power Connector to the wire
5. Finally plug the transformer into the power socket