'A4' Ready-made Kits (Ceiling to Floor)

Ready-made kits, consisting of all fixtures & fittings, and Acrylic Panels; for a complete system!

Installation

Unscrew the Ceiling Fitting into 2 pieces (1 'Brass Mount', and 1 'Chrome Cap with Cable'). Install the 'Brass Mount' to the ceiling. Now screw the polished 'Chrome Cap with Cable' back onto the Brass Mount.

Next unscrew the Floor Fitting into 2 pieces (1 'Floor Mount', and 1 'Chrome Floor Cap' with Spring & Cable').

With the cable already suspended from the ceiling, you can cut it to the length required (a close approximation is fine). Now thread the cable back through the Tension 'Spring', and reattach the Brass Cylinder to the end; as to prevent the cable pulling out from the 'Spring' and 'Chrome Floor Cap'.

With the cable now hanging straight, you can mark and install the 'Floor Mount' to the floor in the correct position. And then simply screw the 'Chrome Floor Cap' with cable attached correctly, back onto this 'Floor Mount'.

The cable MUST be taut before the 'Chrome Floor Cap' has been completely screwed down onto the 'Floor Mount', for the Tension 'Spring' to be effective!