Wall to Floor Pink Cable Fitting, 4m Length

Wall to Floor Pink Fitting is the ideal poster display solution & alternative to the standard 'Ceiling to Floor' pink cable display system - when you are unable to screw cables into the ceiling! A modern, fully adjustable display system for Acrylic Panels, Posters, Frames, Unframed Pictures, Photographs, and more!

Wall to Floor Pink Cable Fitting - Installation

1. Unscrew a wall fitting into (2) pieces (1 'Wall Mount' and 1 'Pink Cover')
2. Screw the brass 'Wall Mount' to the wall that dictates the top of your display.
3. Screw the 'Pink Cover' back onto the 'Wall Mount' (so the 'cable hole' on the end faces downwards, with the 'Grub Screw' located on the side!)
4. Take the 4m cable, thread it through the 'cable hole' of the wall fitting.
5. Tighten the 'Grub Screw' on the side of the 'Pink Cover'.
6. Unscrew the floor fixture into (2) pieces (1 'Floor Mount' and 1 'Pink Floor Cap' with spring & cable.
7. Install the 'Floor Mount' to the floor - using the hanging cable as a guide.
8. Remove the cable from the 'Pink Floor Cap' & spring (Unscrew the brass cylinder)
9. Cut the hanging cable to length required (or a close approximation).
10. Now thread the cable back through the 'Pink Floor Cap', then spring, and reattach the brass cylinder to the end (prevents the cable from pulling out from the spring & floor cap)
11. Re-screw the 'Pink Floor Cap' with the cable attached to the 'Floor Mount'.
12. The cable MUST be taut before the 'Pink Floor Cap' has been screwed down onto the 'Pink Floor Mount' for the spring to maintain cable tension!

Note: Fittings can also be supplied with "Transparent" Perlon Cord! (On request)