'Wall to Floor' Fixed Cable

These Wall & Floor Fittings have direct screw fixing, for a straight forward installation; this option is a great choice when you are unable to attach cables to the ceiling! Once installed, this system is fully adjustable; and very effective at displaying Acrylic Panels, Posters, Unframed Pictures, Photos, and more!

Installation

Unscrew the Wall Fitting into 2 pieces (1 'Wall Mount', and 1 'Chrome Cover'), and screw 'Wall Mount' to the wall, for the top of your display; and screw the 'Chrome Cover' back onto it, so it's 'cable hole' faces downwards, and the 'Grub Screw' is on the side!

Next unscrew the Floor Fitting into 2 pieces (1 'Floor Mount', and 1 'Chrome Floor Cover' with Spring & Cable').

With the cable now hanging straight, you can mark and install the 'Floor Mount' to the floor in the correct position. And then partially screw the 'Chrome Floor Cover' with cable attached correctly, back onto this 'Floor Mount'.

If the cable is still loose when the 'Chrome Floor Cover' is partially attached, loosen the 'Grub Screw' on the side of the Wall Fittings 'Chrome Cover', and pull more cable through it. When the cable has no slack, tighten 'Grub Screw' and tighten the 'Chrome Floor Cover' until the cable goes tight!

The cable MUST be taut before the 'Chrome Floor Cover' has been completely screwed down onto the 'Floor Mount', for the Tension 'Spring' to be effective! Any access cable can simply be cut, to make a neat finish. DO NOT cut any cable, until you are perfectly sure the system has been install correctly!